Some friends found that when he used the motorcycle shock absorber, he would have a noise. This problem was not found when I was operating the motorcycle shock absorber, but since a friend has come up, we have to solve it for you. Let Xiaobian come to analyze and analyze the causes of this problem.
If you find that the motorcycle shock absorber has noise, it may be that the spring of the shock absorber is bent, so that the section and the axis cannot be perpendicular, so that there will be a collision and therefore a sound appears. Or the area that should be fixed is loose, the damping oil is not enough, and the shock absorbing spring is broken. If we have this problem while driving, then we have to stop and check in time. The branch will judge where the problem is. If we find that the spring of the shock absorber is broken, we have to change it.
If the motorcycle shock absorber is caused by oil leakage or wear, then we can drill a hole with a drill at the bottom of the shock absorber. Of course, we must pay attention to the iron scrap when we operate. Go inside, or it will make the oil seal corroded. We can also use the syringe to inject the shock absorber oil into the small hole. Of course, the amount of this oil should be not too full or too little according to the specific situation. We also need to wipe off the surrounding oil traces with a clean cloth and weld the holes with a welder. But remember to solder the speed must be fast, then we have to remove the welding slag.