Gasoline oil prices continue to rise, how to save fuel for motorcycles is a difficult problem for many motorcycle customers. Below, I will give you a brief introduction to some of the little knowledge of motorcycle fuel saving:
1. Motorcycles should be in excellent condition:
1. The air filter should be cleaned frequently (removable if necessary) to keep it smooth. Only the “clean” filter can ensure that the gas is smoothly flowing into the cylinder body to make the gasoline and diesel fully ignite and reduce fuel consumption.
2. For the diesel engine to obtain sufficient lubrication, the engine oil of the diesel engine should be replaced on time (preferably the original automobile oil is applied), so that the diesel engine can reduce the friction during operation and reduce the dynamic energy loss.
3. Effective tire pressure standard is a key element for fuel-efficient driving. The tire pressure standard should meet the requirements in the instructions. If the standard air pressure is not enough, the tire will cause excessive calorie consumption and increase fuel consumption.
4. For the petrochemical car, it needs to be adjusted to the index value category to prevent the car from being too slippery due to the low speed, and the need to continuously start the diesel engine, resulting in the extravagance and waste of gasoline and diesel.
5. To ensure the excellent ignition characteristics of the motorcycle spark plug, it is necessary to immediately replace the appropriate ignition coil when the ignition coil ignition characteristics are not good.
6. When the engine camshaft, cylinder, valve rocker arm, piston ring, cylinder block, clutch plate, etc. are damaged, the fuel consumption will be increased and should be replaced immediately.
7. It is not necessary to install the windshield on the front bumper. The installation of the windshield will increase the frictional resistance when the car is driving, resulting in an increase in fuel consumption.