Today, let's share with you how to simply repair and maintain your motorcycle front shock absorption.
Use the front shock absorber to remove the wrench, remove the rubber cover at the upper end of the front shock absorber, pull out the stop ring, remove the parts such as the cover, gasket, inner sleeve and shock absorbing spring, and then pour the hydraulic oil in the shock absorber. clean.
Clamp the front shock absorber on the vise (be careful not to clamp too tightly), use a wrench to hold the piston rod, and use the inner hexagon wrench to loosen the fastening bolt at the root of the outer fork tube to remove the inner fork tube. component. The installation is carried out in the reverse order of disassembly and disassembly. The front shock absorber cleaner removes grease and makes the shock absorption smoother!
The assembly points are:
(1) When installing the oil seal, the main lip should be facing the outer fork tube, the dust lip should be facing outward (that is, the numbered side of the oil seal faces outward), a small amount of grease should be applied to the lip, and then the block and the hammer are used. Gently push the oil seal into the outer fork tube (or screw it in with a special tool).
(2) All parts must be cleaned before assembly.
(3) The main lip of the oil seal shall not be scratched.
(4) Do not leak the sealant or gasket when installing the oil drain plug.